Exploiting Surface Water Resources

Nov. 9, 2007

About the author: Evelyn M. Scibelli is municipal sales manager for Koch Membrane Systems, Inc. She can be reached at 978.694.7195 or by e-mail at [email protected]


For more than two centuries, the Edwards Aquifer, one of the most prolific artesian aquifers in the world, has enabled San Antonio and the surrounding region to grow and prosper without utilizing surface water. An artesian aquifer is a geological formation in which water is under sufficient hydrstatic pressure to be discharged to the surface without pumping.

Historically, the Edwards Aquifer was able to serve the diverse agricultural, industrial, recreational and domestic water needs of almost two million users in south central Texas, allowing San Antonio to emerge as America’s eighth largest city, despite the semi-arid climate at the edge of the vast Chihuahuan Desert.

During recent decades, however, demand for water in the region has increased well beyond the aquifer’s capacity, leading to concerns about the welfare of endangered species and regional economies that depend on spring flows from the aquifer.

Strict limits have been placed on the use of the aquifer, forcing water districts to rapidly develop surface water resources to satisfy existing potable water needs and support future growth. The challenge has been to increase capacity while meeting the stringent regulatory requirements of the Safe Drinking Water Act (SDWA). The Surface Water Treatment Rule (SWTR) requires surface water to be filtered and disinfected prior to distribution to control Giardia, Cryptosporidium, viruses, turbidity and coliform bacteria.

UF exceeds expectations

To meet the capacity requirements and safe water regulations, several water districts have turned to ultrafiltration (UF) membrane technology. One of the first to do so was Canyon Regional Water Authority (CRWA) at its plants in New Braunfels and San Marcos, northeast of San Antonio.

“When we were faced with the need for rapid expansion of our surface water treatment capacity, we decided to utilize membrane filtration because it could filter far more water at a lower cost and in a smaller footprint than the conventional sand filtration system we had in operation,” said David J. Davenport, general manager of CRWA.

In June 2002, the New Braunfels plant commissioned a 4-million gal per day (mgd) UF system composed of two parallel units, each containing 48.8- x 72-in. PMPW hollow-fiber cartridges from Koch Membrane Systems, Inc. (KMS) of Wilmington, Mass. A single, 2-mgd unit was also installed at a newly constructed CRWA plant in San Marcos.

“Within a month of commissioning the new membrane system, it was immediately put to the test by a 500-year flood and exceptionally high turbidity levels,” Davenport said. “It was amazing to see the membrane system continue to perform while the conventional sand filtration systems in the local area needed to be shut down.”

The turbidity levels rose to record highs, reaching 4,000 NTU on July 5, 2002. The membrane system continued operating throughout the crisis, providing water to the two above-ground clearwells and continuing to distribute high quality water to CRWA’s customers. “This experience demonstrated the most beneficial aspect of membrane technology: its ability to supply quality drinking water regardless of the turbidity levels in the feedwater,” Davenport said.

During a normal July and August, when demand for water is at its highest, the turbidity of the feedwater from the Guadalupe River typically fluctuates between 6 NTU and more than 100 NTU, averaging approximately 17 NTU. The PMPW polysulfone membranes have a pore size that provides a 100,000 molecular weight cutoff. This mechanical barrier produces consistent product water quality below 0.05 NTU, regardless of feedwater turbidity.

Additionally, PMPW membranes from KMS are credited with 4-log (99.99%) removal of Giardia, Cryptosporidium and viruses by the California Department of Health Services.

Capacity expansion on a small footprint

By mid-2003, the CRWA needed to increase capacity to meet customer growth that was outpacing earlier projections. CRWA decided to install the PMPW-10 cartridge, a newly available 10-in.-diameter UF hollow-fiber cartridge from KMS, containing 60% more membrane area and capable of filtering 60% more product water than its 8-in. predecessor.

During the summer of 2005, six PMPW-10 filtration units were commissioned, producing 14.4 mgd at the New Braunfels plant. The original two PMPW-8 units were moved to the San Marcos plant to expand the previously installed PMPW-8 system.

Low maintenance

“Our systems are highly automated,” Davenport said. “They maintain low transmembrane pressure, with a once-a-month cleaning routine.” The monthly clean-in-place protocol consists of recirculating softened potable water containing 200 ppm of chlorine through the membranes at 95 to 110ºF at a pH adjusted to 12 with sodium hydroxide. Occasionally a citric acid solution (pH 3.0) is used.

The use of chlorine dioxide to control algae has been an effective pretreatment step for the New Braunfels system. Approximately 1 ppm of chlorine dioxide is injected into the raw water line year-round, with a typical residual of 0 to 0.3 ppm going into the membrane system.

High automation and low maintenance are not only important at larger facilities but smaller ones as well. This is exemplified at the Martindale Water Supply Corp., a 0.5-mgd facility located a dozen miles southeast of the San Marcos plant. A 13-cartridge PMPW-8 system, brought online in February 2001, filters well water for 2,500 Martindale area residents. This facility also must comply with the SWTR because it uses groundwater under the influence of surface water.

“I am the only employee at this facility besides the office manager, and therefore ease of maintenance is critical,” said Steven Fonville, general manager of the Martindale Water Supply Corp. “We barely have to clean the membrane system; however, we do perform cleaning every six months as a formality, so we don’t forget how the process works.”

Success and growth

Successful operation of membrane UF plants at the New Braunfels, San Marcos and Martindale plants has spurred wide interest in the technology in south central Texas.

“We were one of the first plants, and now there are 15 to 20 similar plants in Texas in construction or in the process of coming online,” Fonville said.

Membrane UF technology provides the San Antonio region with a cost-effective method of developing and utilizing surface water resources. This technology enables continued economic growth, while conserving the limited capacity of the Edwards Aquifer.

Download: Here

Sponsored Recommendations

2024 Manufacturing Trends Unpacking AI, Workforce, and Cybersecurity

April 25, 2024
The world of manufacturing is changing, and Generative AI is one of the many change agents. The 2024 State of Smart Manufacturing Report takes a deep dive into how Generative ...

State of Smart Manufacturing Report Series

April 25, 2024
The world of manufacturing is changing, and Generative AI is one of the many change agents. The 2024 State of Smart Manufacturing Report takes a deep dive into how Generative ...

ArmorBlock 5000: Boost Automation Efficiency

April 25, 2024
Discover the transformative benefits of leveraging a scalable On-Machine I/O to improve flexibility, enhance reliability and streamline operations.

Blower Package Integration

March 20, 2024
See how an integrated blower package can save you time, money, and energy, in a wastewater treatment system. With package integration, you have a completely integrated blower ...