Branford, Conn., was first settled in mid-1644 as part of the New Haven Colony and officially renamed in 1653 after the town of Brentford, England. Branford owns and operates the Water Pollution Control Facility on Block Island Road. The facility collects sewage from about 100 miles of sewers and 50 pump stations in Branford, as well as sewage from a portion of North Branford.
Among the pump stations managed by Branford is a long-term problematic station located at Burban Street. There were two primary problems at this station: clogging from modern day trash and raggy, stringy materials; and fats, oils and grease (FOG) from a nearby nursing home and restaurants, which accumulate and float on the water surface, resulting in a horrendous mess.
If town staff did not travel to the station weekly and clean it with a vacuum truck or fire hose, the FOG would congeal and become an even a bigger problem, requiring many additional labor hours to resolve. Town staff would spend at least one to two hours with one or two personnel every week at this site.
To solve these two nagging problems, pumping equipment at the Burban Street station was recently upgraded as part of a capital project, and Branford chose to use Flygt N-technology pumps to eliminate clogging issues. Two Flygt NP 3171 HT model submersible pumps were installed, each capable of handling up to 1,300 gal per minute (gpm) and 63 ft of total dynamic head. These pumps feature explosion-proof 34-hp motors and high-chrome impellers. They also are more efficient than their predecessors, which will save Branford money by reducing energy costs.
Clogging issues were quickly resolved with N-pump technology, which causes solid objects to slide along the tip of the impeller vane and out through a relief groove. However, FOG problems continued to plague the town, which then began evaluating different solutions, such as mechanical or bubble mixers, knowing all the while that new equipment may or may not have resolved the issue. The addition of more mechanical equipment in the basin that would also need to be maintained was the main concern. The mechanical mixer required routine maintenance, and the bubble mixers had a compressor that not only needed routine maintenance, but also was loud and required a heated enclosure.
At this juncture, Branford’s local Flygt representative, GA Fleet Associates, approached the town with a possible solution, offering a demo option of a Flygt MultiSmart controller. Following initial discussions, a MultiSmart control panel with a Flygt PumpView3 supervisory control and data acquisition (SCADA) system was quickly shipped to the site. Manufacturer’s representatives and experts were on hand to support the town for the startup of the controller and setup of the SCADA system.
MultiSmart’s wet well cleaning; pump reversal; flow metering, energy calculation and pumping efficiency; and FOG ring-avoiding functions were enabled and continuously monitored remotely by town personnel. Wet well cleaning is highly successful due to both the N impeller and pump reversal features that permit snore cycles to keep the wet well clean. Using phase and energy monitoring, Branford personnel are able to predictively monitor pump efficiency looking for changes that might require routine maintenance.
Wet well cleaning was operating every fifth cycle with alternating pumps and snoring. Pumping was continued an additional 30 seconds as the check valves of the pump station were 30 ft away and required this amount of time to ensure the FOG and any other floatable solids were completely pumped out of the station. Although it is not optimal to allow other pumps to snore, the new pumps are designed to run dry if needed because their closed-loop cooling system prevents them from overheating.
The new pumps and controls have given Branford a complete solution for its pumping stations. The town is interested in converting other problematic pump stations and utilizing MultiSmart functions elsewhere, including phase monitoring to prove to the utility company that there are over- and under-voltage situations at times at other pump stations.
Editor's Note: Scranton Gillette Communications and the SGC Water Group are not liable for the accuracy, efficacy and validity of the claims made in this piece. The views expressed in this content do not reflect the position of the editorial teams of Water & Wastes Digest, Water Quality Products and Storm Water Solutions.