Bulk Bag Unloader, Flexible Conveyor Improve Filtration Effectiveness at Winery

Dec. 28, 2000

Beringer Wine Estates, St. Helena, Calif., improved filtration effectiveness in its diatomaceous earth (DE) unloading and winery waste filtration area by an automated bulk bag unloader and flexible screw conveyor. The winery replaced a manual DE unloading setup with this automated, enclosed unloading and conveying method from Flexicon Corporation.

The automated bulk bag unloader lifts 1,000-lb. bulk bags of DE by an electric hoist and trolley at the top of its 16-foot-high cantilevered I-beam frame. Aided by flow promotion devices, the unloader fully discharges bulk bags into the 30* hopper below. From the hopper, a flexible conveyor, at a 45° angle, moves the DE to two 12-foot-high, 1,500-gallon slurry tanks of winery waste.

Optimal Filtration

Filtration efficiency was optimized by the bulk bag unloader’s loss-in-weight control that precisely meters diatomaceous earth into the two 1,500-gallon slurry tanks. The bulk bag unloader is mounted on load cells that transmit loss-of-weight information to a controller. As the flexible conveyor feeds the slurry tank, the controller, on reaching the set weight, slows the speed to a dribble before stopping the conveyor, delivering the target dose.

"Dispensing accuracy gives us more filtration runs per amount of DE consumed," said John Pepe, director of cellar operations. "Otherwise, adding too little DE would allow effluent to plug the filters following the slurry tanks, or too much DE would clog the filters. Both situations would prompt more filtration runs than needed."

Beringer Wine Estates recouped its investment for the automated system in less than three years out of savings from the dispensing accuracy and buying DE in bulk bags rather than 50-lb. hand sacks that workers previously had to manually open and dump.

Modified System

In installing the bulk bag unloader, Flexicon modified an existing bulk bag frame from an earlier attempt by Beringer at automated bulk bag unloading. The former system metered the diatomaceous earth to a horizontal screw auger. The unloader was controlled based on timing rather than weight.

Flexcon added an agitator to the new system to eliminate bridging and caking of DE in the hopper and changed the conveyor screw to its Bevcon design to exert less compression on the material.

The system has since run with no problems.

Sponsored Recommendations

Get Utility Project Solutions

June 13, 2024
Lightweight, durable fiberglass conduit provides engineering benefits, performance and drives savings for successful utility project outcomes.

Meeting the Demands of Wastewater Treatment Plants

May 24, 2024
KAESER understands the important requirements wastewater treatment plant designers and operators consider when evaluating and selecting blowers and compressed air equipment. In...

Modernize OT Cybersecurity to Mitigate Risk

April 25, 2024
Rockwell Automation supports industry-leading Consumer Packaged Goods company, Church & Dwight, along their industrial cybersecurity journey.

2024 Manufacturing Trends Unpacking AI, Workforce, and Cybersecurity

April 25, 2024
The world of manufacturing is changing, and Generative AI is one of the many change agents. The 2024 State of Smart Manufacturing Report takes a deep dive into how Generative ...