SmartMeter Proves to be Smart Choice for Illinois City

July 22, 2015
Faced with the dilemma of replacing aging water meters and losing nearly $1.5 million in revenue, the Village of Tinley Park opted to install the Severn Trent Services SmartMeter SE700.

In 2001, Severn Trent Services developed and launched the SmartMeter SE700 , a water meter specifically aimed at the North American market. Soon after, Tinley Park, Ill., ordered 5,000 intelligent meters and SmartPad devices to enable the water meters to be read remotely. The Village also received SmartReader handheld devices to read the newly installed SmartMeters.

A few years after the initial SmartMeters were installed, the Village needed to have the remaining meters replaced. Rather than make a snap decision, the Village decided to undertake a detailed cost benefit analysis to determine the best solution. This consisted of two activities: a theoretical calculation of the loss of revenue from the mechanical meters, and an analysis of the actual earning performance of SmartMeters compared to the mechanical meters.

The test
The Village removed a number of old mechanical meters to test their accuracy and establish the potential effect on revenue of a variety of replacement strategies. A weighted analysis against typical consumption, including low (20%), average (65%) and high (15%) flow rates, was undertaken on the removed meters.

The meters analyzed ranged from four to 15 years in service, with an average of approximately 12 years across a sample of 104 meters. The weighted average accuracy of the meter sample was found to be 89.3%, which equates to a revenue recovery loss of approximately $8.62 per meter per quarter, or $34.48 per year, based on an average quarterly utility bill of $71.97.

Assuming the sample is typical of the installed base, the theoretical revenue loss for the next 12 months was estimated at $474,273 across the 13,750 meters subject to replacement. In addition to the theoretical revenue losses, the analysis of actual consumption figures highlighted the consistent performance of the SE700s in generating revenue, compared to the consistent under-registration and progressive loss of performance of the Village’s aging mechanical meters. As a result, the SE700’s installed by the Village all demonstrated consistent performance in earnings, while the accuracy and revenue generated by the mechanical meters dropped considerably over time.

Additional consideration
Rather than focus exclusively on the initial capital cost, potential long-term whole life cost savings was also an important consideration. In the Tinley Park example, if no meters were exchanged, the minimum revenue losses would be more than $474,273 per year. Over three years this would result in a theoretical minimum total loss of revenue of over $1,422,819, which is higher than the cost of replacing all of the meters.

SmartMeter water meters are designed to overcome the billing problems caused by grit and air in the distribution system. The design has no moving parts, which ensures that metered flow and income remain accurate over the entire product lifetime. Typical payback of SmartMeters is roughly three years, depending on the cost and quality of water available.

Tinley Park receives its water supply from Lake Michigan, which offers high quality water that is low in particulates. Most wear would be due to the mechanics of the meter, rather than any grit passing through the water distribution network. In places where the water quality is lower, even greater wear and higher revenue losses occur by using mechanical meters.

The Village of Tinley Park elected to replace the entire installed base of mechanical meters with SmartMeters over the following three years. One year after this change, all the meters supplied by Severn Trent Services are continuing to show consistent revenue recovery.

Fran House is a Marketing Manager for Severn Trent Services. She can be reached at 215-997-4058, or by email at [email protected].

About the Author

Fran House

Sponsored Recommendations

2024 Manufacturing Trends Unpacking AI, Workforce, and Cybersecurity

April 25, 2024
The world of manufacturing is changing, and Generative AI is one of the many change agents. The 2024 State of Smart Manufacturing Report takes a deep dive into how Generative ...

State of Smart Manufacturing Report Series

April 25, 2024
The world of manufacturing is changing, and Generative AI is one of the many change agents. The 2024 State of Smart Manufacturing Report takes a deep dive into how Generative ...

ArmorBlock 5000: Boost Automation Efficiency

April 25, 2024
Discover the transformative benefits of leveraging a scalable On-Machine I/O to improve flexibility, enhance reliability and streamline operations.

Blower Package Integration

March 20, 2024
See how an integrated blower package can save you time, money, and energy, in a wastewater treatment system. With package integration, you have a completely integrated blower ...