Eco-Friendly Water Treatment for Winston-Salem

April 3, 2018
Utility turns to pump-equipped biosolids-drying facility to reduce disposal volume

When increased production demands and rising disposal costs prompted the need for an expansion at the Elledge Wastewater Treatment facility in Winston-Salem, N.C., the solution was an Andritz biosolids dryer facility.

Prior, the facility was using conveyors to move dewatered sludge from its centrifuge to a storage building. From here it was loaded onto trucks and transported to privately-owned sites chosen for the city of Winston-Salem Class-B Land Application Program.

“Due to higher restrictions on the class-B product, reduced landfill space and increased landfill cost, Winston-Salem looked for a way to reduce disposal volume and make the product user-friendly,” says Bruce Casey, Biosolids Drying Facility plant supervisor. 

The new seepex Andritz biosolids dryer facility will turn the dewatered sludge into a marketable Class A, EQ (Exceptional Quality) fertilizer pellet.

Now, conveyors are depositing the sludge into a custom extended-hopper seepex BTI 70-24 progressive cavity pump with paddle mixers to prevent bridging on top of the feed auger. Seepex will custom-design hopper extensions to meet any application. The pump size 70-24 can handle up to 640 gal per minute (gpm) dewatered biosolids. The BTI design pump can handle up to 35% dry solids contents. A ribbon-screw auger moves the cake into the compression zone at a rate that is three times greater than the physical capacity of the pumping elements. The high shear of the ribbon-auger and circulation of the thixotropic sludge reduces the apparent viscosity, so it is easier and more efficient to pump.

The pressure side of the pump is fitted with a chemical injection ring, which meters polymer into the annulus of the sludge pipe, using a MD 012-24 seepex metering pump.  Polymer injection reduces the friction loss from the cake and the resulting discharge pressures by up to 80%. The discharge pipe is fitted with a pressure switch that activates the polymer injection pump when the pressure reaches unsafe levels. The BTI pumps then sludge through 120 ft of 12-in. pipe to the dryer building, located on the right side of the original building.

When the sludge arrives in the building, it is deposited in a 24-hour storage bin. A second seepex BTE 70-24 sits below the storage bin. Here the dewatered sludge is pumped to a mixer and blended with pellets. The auger forces the material into the compression zone where it is moved into the piping by the cavities formed between the rotor and stator (materials are custom selected for every application). The mixture is then run through the Andritz dryer system. The resulting product is fertilizer pellets.

By using seepex progressive cavity pumps instead of conveyors they contained the sludge and saved roughly $1,500 in capital costs per foot of conveyor.

“We needed to find a way to reduce cost and with the help of the seepex pumps we now have a system in place which will allow us to maintain economical and ecofriendly water treatment for Winston Salem,” said Casey.

Sponsored Recommendations

Blower Package Integration

March 20, 2024
See how an integrated blower package can save you time, money, and energy, in a wastewater treatment system. With package integration, you have a completely integrated blower ...

Strut Comparison Chart

March 12, 2024
Conduit support systems are an integral part of construction infrastructure. Compare steel, aluminum and fiberglass strut support systems.

Energy Efficient System Design for WWTPs

Feb. 7, 2024
System splitting with adaptive control reduces electrical, maintenance, and initial investment costs.

Blower Isentropic Efficiency Explained

Feb. 7, 2024
Learn more about isentropic efficiency and specific performance as they relate to blowers.

Seepex Inc.

April 26, 2018