Sealing Methods

What is L3/D4 (L cubed over D to the fourth)? It is a

measure of pump rotor stiffness, its ability to resist radial load and to

minimize deflection. It comes from the basic cantilevered beam deflection

formula, which you can find in any book on mechanics: y = F x L3 / (3 x E x I),

where F is radial load, L is cantilevered length, E modulus is the elasticity

of the material and I is moment of inertia. (See Figure 1.)

Load F could be a cantilevered weight of the overhung load,

a centrifugal force created by the end load unbalance, a hydraulic radial

thrust of a centrifugal pump or a combination of forces. These forces can be

static and not changing direction such as weight or dynamic such as rotating

unbalance.

For circular shafts, I = 3.14 x D4 / 64, and thus a

deflection at a given force is proportional to y ~ L3/D4, or abbreviated it

often is written as L3D4

Thus, L3D4 becomes a criterion for an indirect assessment or

a comparison of a rotor deflection under load. Mechanical seals cannot tolerate

much deflection and are prone to leakage if their faces are displaced by more

than 0.001?0.002 inches.

The lower the L3D4, the less shaft deflection, which is

better for the seals. If L3D4 becomes too large, a pump shaft can snap,

especially if operated close to shut-off where hydraulic radial loads are

excessive.

ANSI pumps have L3D4 ratios that range from 20 to 120, but

new designs have been introduced with this ratio below 10.

You easily can determine the L3D4 ratio of your pump by

measuring the length of the shaft from the center of the bearing closest to the

impeller and impeller center line and the diameter of the shaft under the

bearing. Then, cube the length, raise the diameter to the fourth power and

obtain the ratio. A shaft diameter changes from the bearing towards the

impeller, but its value under the bearing is taken nominally. By tabulating

these ratios for different pumps, you can make your own plant database of L3D4

of different designs.

As a word of caution, the ultimate manifestation of pump

reliability is its operating history, which could at times conflict with what a

L3D4 number would indicate. Nevertheless, it is a good guide and helpful as one

of several design factors that may have an effect on the pump reliability.